IDTECK Star iCON100SR, Руководство пользователя

Страница: 29 / 90

p.23 Device Setting
3.3 Baud Rate Setting
Baud rate is the speed rate during communication with host PC. The 3 DIP switches are assi
gned for baud rate setting on the upper left side of the iCON100 board. You can select one
of 4800bps, 9600bps, 19200bps, 38400bps, 57600bps and 115200bps.You have to set ap
plicable baud rate according to communication environment, and the connected devices on
one loop must have the same baud rate. If DIP switch turns from ‘ON’ to ‘OFF’ or ‘OFF’ to ‘ON’
, buzzer is generated. Also under TCP/IP communication, the baud rate has to be matched
with TCP/IP module.
Baud rate must be the same as the values set by application software (Starwatch d
ual pro I, II) and the baud rate of all products on the same loop must be same.
If you use ver. 6.0 and lower with ver. A1.0 and higher together, set the baud rate
to 9600bps only. When you only use ver. A.1.0 and higher, you can set other baud
rate including 9600bps.
If you set high baud rate in bad environment for communication, communication
may not properly operate. In this case, let baud rate lower.