IDTECK Star iCON100SR, Руководство пользователя

Страница: 27 / 90

p.21 Device Setting
2 System Initialization of iCON100
Initialization must be performed before first installation of iCON100. Press down the two init
ialization switches simultaneously then keep pressing more than 2 seconds. Once buzzer sou
nd is generated, release the switches then initialization is done and system restarts automati
cally.
If you initialize the iCON100, all data such as user ID, baud rate, door setting, time
schedule and event information stored in the controller will be cleared and the def
ault values (factory setting values) will be reloaded. Therefore, the Initialization sho
uld be performed by authorized person only. It is recommended to upload all even
ts data before initialization in case you use events data for time and attendance pu
rpose.
3 Device Setting
3.1 26Bit / 34Bit Wiegand Setting
Select the data format (26bit/34bit) input to reader port. There is a switch for bit setting on
the upper left side of iCON100 board. The switch is set to ‘OFF’ position as the default (26Bit
Wiegand setting). If the switch is set to ‘ON’ position as shown below table, the system is set
to 34Bit Wiegand.
●
26bit Wiegand type format: Using 26bit Wiegand format reader (RF10, 20, 30, 70 RFK1
01.)
●
34bit Wiegand type format: Using 34bit Wiegand format reader (SR10, 20, 30 SRK101)