Mounting the
electrisave™
The Main Unit Receiver can either be placed on a flat surface with the back stand pulled out or mounted as shown below:
The Remote Transmitter should be placed on a flat surface or mounted on a wall using the wall bracket provided within 30
metres of the Main Unit Receiver. It should be mounted outside of the electrical meter or fuse box, if these are made of
metal.
WARNING: If installed inside a metal meter box, the signal transmission distance between the remote
transmitter and the main receiver will be reduced.
To fix the wall bracket follow the instructions below:
Attaching the Current Sensor
WARNING: If in doubt about installing this product yourself, please consult a qualified electrician
To attach the Current Sensor to the household power line (see
HOW THE PRODUCT WORKS)
follow the steps below:
10
Diagram
Instructions
1. Mount by using nails or screws.
Diagram
Instructions
2. Hammer in nail or screw halfway.
1. Position the wall bracket.
2. Insert nail or screw through the mounting hole.
3. Hammer in nail or fix the screw halfway.
4. Attach wall bracket.
5. Slide Remote Transmitter into place.
3. Attach main unit
Locate the main household active or ‘phase’ cable (see
How the product works).
Thread cable through. Re-clasp cable housing.
Unclasp the housing, following the letters in the Diagram
above.
Current Sensor with cable properly attached.
