IDS IDS806, Руководство пользователя

Страница: 24 / 32

Owner’s Manual
700-624-01C
24
Troubleshooting
Trouble Conditions
In the event of a trouble condition the power indicator will flash. Trouble Condition
refers to Low Battery power and/or AC Mains Failure. Check that the plug is in place and
switched on. If the power indicator is still flashing once these checks have been done,
contact your installer who will then check the battery power.
Viewing Trouble Conditions
Hold down the [7] until the beep
If the POWER LED is flashing (or if so programmed, the keypad is beeping) hold down the
[7] key for one second. The ARMED, AWAY, and READY indicators will start flashing to
show that the keypad is in the TROUBLE viewing mode. Refer to the table below to find
the significance of each lit zone LED. The system will automatically exit the TROUBLE
mode after ten seconds. To clear the trouble condition press [#] after viewing the
trouble. To simply cancel the beeping without viewing the trouble conditions, press [#].
Please see Table 3: Trouble Condition Indicators below for all trouble conditions:
NOTE:
Trouble condition 1: Wireless Trouble is the only trouble condition that can be drilled
into for more information.
Table 3: Trouble Condition Indicators
Indicator Trouble Condition
1 Wireless Zone Trouble (To see more information enter [1][*]
Zone LEDs will show which wireless zones are in trouble, enter
[Zone] followed by [*] to see trouble indicator)
** No zones indicate a signal jamming condition **
Zone Trouble Description
1 Wireless detector battery low
2 Supervision fail
3 Tamper occurred
3 Mains power failure
4 Low battery or disconnected
6 The siren wire has been cut
7 Keypad housing has been opened tampered with