IDS IDS806, Руководство пользователя

Страница: 18 / 32

Owner’s Manual
700-624-01C
18
Deleting User Codes
Follow steps 1-5 of the previous procedure but in step 6 only press the [*] key. That
particular code will be deleted.
Maid’s Code
The maid’s code (user 14) may be used to limit access to the premises. The maid’s code
will only disarm the system if the same code was used for arming. If armed with a code
other than a maid’s code, the system will view an attempt to disarm with the maid’s
code as an invalid entry. Any valid user code will disarm the system if it has been armed
with the maid’s code.
EXAMPLE:
If a maid is expected on a Monday, arming the system on a Monday morning using the
maid’s code will allow the maid to disarm the system. On days that any other user code
(i.e. not a maid’s code) has been used to arm the system entering the maid’s code will
not disarm the system.
Stay Zones
Stay zones are those zones which are bypassed automatically when the system is STAY
ARMED. To avoid triggering the alarm, zones such as bedrooms, or other areas which
require access, must be bypassed. Stay zones need only be programmed once. Each time
the system is armed in the stay mode the preselected stay zones will be bypassed
automatically. This also depends on which stay profile is active.
NOTE:
Zones, such as panic zones, Arm/Disarm zones cannot be selected.
To Program Stay Zones
+ [ZONE NUMBER] +
1.
Hold down the [3] key until the keypad buzzer sounds. The AWAY indicator will flash
to show that the panel is in the Stay Zone programming mode.
2.
Press the [NUMBER] corresponding to the zone you wish to be a STAY zone.
3.
The relevant zone indicator will come on. (Buzz zones will be shown by flashing
indicators. See Pg. 19. A Buzz zone cannot be selected as a Stay zone; the Buzz status
must be cleared first.)
4.
Repeat step 2 until all stay zones are selected.
5.
Press the [#] key to exit the Stay zone programming mode.