1.6.
HYYP Hub LEDs
LED 1 – Transmission LED flashes when communicating with the network.
LED 2, 3, 4 – Signal Strength. All 3 is strong signal, 2 & 3 is fair signal and just 2 is poor signal.
LED 5 – APN LED indicates connection to the platform. (This must be on)
5 4 3 2 1 Antenna
1.7.
HYYP IP Connect LEDs
The HYYP IP Connect Module has 4 LEDs that you can use to view its status.
Power LED – On when the HYYP IP Connect Module has sufficient power.
Panel Comms LED – Flashes when communicating with the X-Series
Panel.
Network Comms LED – Flashes when communicating on the network.
Server Auth LED – On when connected to the HYYP platform.
On power up the Network Comms and Server Auth LEDs will flash
together, and once it has made a successful connection to the HYYP
platform the Server Auth LED will stay on and the Network Comms LED will flash
when it’s communicating on the network.
If the Server Auth and Network Comms LEDs continue to flash the same number then there is
an error on the HYYP IP Connect Module. You can determine the error by the amount of times
the LEDs flash.
See error numbers below:
1 – System error –
Replace unit.
2 – Can’t initialise Ethernet port. –
Router not connected.
3 – Can’t get IP address from DHCP server. –
Router not supplying IP Address.
4 – Can’t connect to the Time server. –
Isn’t connected to the internet.
5 – Unable to log on to the HYYP platform.
6 – Unable to register on the HYYP platform.
Remember:
When using the IP Connect you must go back to location 196 and enter * when asked to press
sync button.
