IDS 816, Руководство по установке

Страница: 21 / 64

IDS 816 700-283-02I Issued September 2009
21
Sub-location 2 Zone Properties
NOTE:
Select all the options for each zone. Shaded areas in the table indicate default values. This is a
bitmapped location.
LED ON / OFF Zone Properties
1
ON Tamper by zone enabled
OFF Tamper by zone disabled
2
ON Cross-zone enabled
OFF Cross-zone disabled
3
ON Shutdown zone enabled
OFF Shutdown zone disabled
4
ON Silent zone enabled
OFF Silent zone disabled
Default values are shaded
Further zone related functionality explained
Tamper by Zone
Individual zones may be enabled for tamper by zone. For connection details, see Figure 2. This feature is
not available if zone doubling is enabled. (Figure 3, page 11 and location 38, page 24)
Cross-zoning
This feature is useful for reducing false alarms. Violating zones with the cross-zone property enabled will
not immediately generate an alarm. The cross-zone delay timer is started. (location 36).
Depending on the value programmed into location 37 (Cross-zone Trip Count), the zone (or
any other zone with cross-zone option enabled) must trip the number of times programmed into location
37 before an alarm is generated. An alarm will also be generated should any single zone remain violated
for the entire delay period (location 36). An entry/exit cannot be cross-zoned.
Swinger Shutdown
During a single arm cycle, if the number of alarm violations generated by a swinger zone equals the
shutdown count (location 33), the control panel will automatically bypass the zone. The swinger
shutdown counter will reset when the system is disarmed and can be programmed to reset automatically
when the 24 hour self test report is generated. (Sub-location 5 of locations 128 and 129).
Silent Zone
This property allows any zone that would ordinarily activate the siren to be programmed as a silent zone
i.e. the violation of a silent zone while the system is armed will not activate the siren. However, the
relevant reporting code (if programmed) will still be reported.
Zone Reporting Codes
NOTE:
For the following locations, a two digit hexadecimal code must be programmed. To disable a reporting
code a double zero (00) must be entered. If a zero is to be reported, it must be entered as hexadecimal
value A, i.e. [MODE] [0] . In the event that only 1 of the digits is programmed or an A is incorrectly
programmed as a zero the code will not be reported. If domestic reporting is used, only the first digit of
the reporting code is required / used.