IDK MSD-702UHD, Руководство пользователя

Страница: 99 / 150

MSD-701UHD / 702UHD / 801UHD/ 802UHD User’s Guide
99
[Table 9.22] Setting items of control command (Cont’d)
Item
Setting
Description Range
COM CC CEC
RECV DISPLAY yes no no Set whether received data is displayed or
not.
OFF [Default]
ASCII
HEX
DELIMITER
*1
yes no no Set the delimiter to be sent at the end of the
received data.
“NONE”: delimiter is not checked and all
received data within the set timeout will be
valid.
Value other than “NONE”: delimiter is
checked and data received before delimiter
will be valid.
NONE [Default]
00 to FF (Hex)
RCV CHECK
*2
yes no no Set whether reply command that may be
returned is checked or not.
CHECK
NOT CHECK [Default]
TIME OUT
*3 *4
yes no no Set the timeout time for reply command to a
sent command.
0ms to 99s999ms
[Default] 0ms
RETRY
*3 *4
yes no no Set the number of retries to resend the
same command again if no valid response
is replied.
0 to 99 (times)
[Default] 0
INTERVAL
*3 *4
yes no no Set the retry interval to resend the
command.
0ms to 99s999ms
[Default] 0ms
ERROR
*3 *4
yes no no Set whether the next command is to be
executed or not if no valid response is
replied, even after completing retry for the
set number of retries.
STOP [Default]
EXEC: continue
Contact closure
control
no yes no Set the contact closure control.
If you select “toggle operation”, it can invert
the condition of contact (open/close).
-: not control [Default]
OFF: contact open
ON: contact close
TGL: toggle
Pulse width no yes no Set the time of returning its original
condition when you control the contact
closure.
NONE: eternity [Default]
100ms to 9990ms (by
10ms)
HDMI CEC
control
*7
no no yes Set the CEC control for the sink devices
connected to OUT1A / OUT2A / OUT1B /
OUT2B.
-: not control [Default]
POWER OFF
POWER ON
Process for CEC
error
no no yes
Set whether the next command is executed
or not if no response is replied from the sink
device that is controlled with CEC.
STOP [Default]
EXEC: continue
MEMO yes yes yes
Register a note up to 14 characters.
The registered note is displayed when the
control command is executed.
20 to 7D in ASCII codes
except for 2C (,)
[Default] 20 (space)