HDC-TH401/201/101 User Guide
27
7.4 Setting EDID resolution
You can set EDID that is sent to a connected HDMI source device.
EDID settings 3 to 22 sets the built-in EDID.
EDID accured in “
” and external EDID that is loaded from sink devices can be selected.
See “
[Table 7.4] The maximum resolution of EDID
”” for details of EDID setting number.
Note:
The sorce device loads EDID of the HDC-THx01 (transmitter). Even if settings of the HDC-Sx00 (distribution
amplifier)/HDC-RHx01 (receiver) are set, the source device cannot load the EDID.
HDC-TH401/201/101
TX
HDC-RH401/201/101
Projector
RX
Laptop
HDC-S400/200
Splitter
[Fig. 7.4] Reading EDID
1) Resolution setting 1 (External EDID)
Selects external EDID. The HDMI output connector can be selected in “
”.
2) Resolution setting 2 (Copy EDID)
Selects EDID that is acquired in “
”.
EDID copy data 1 to 3 can be selected in “
”.
3) Resolution setting 3 to 6 (For TVs and others; built-in EDID for HDMI devices)
The same timing EDID of CEA-861E HD signals
4) Resolution setting 7 to 22 (For PCs and others; built-in EDID for DVI signals)
VESA DMT or VESA CVT complicant timing
For 1600x900, 1920x1200, VESA1080, and 2048x1152, only Reduced Blanking is supported.
Use this menu to set EDID that is sent to the source divice from the HDC.