FDX-32 Users Guide
57
8.6.10 Switching effect [OUTPUT FADE OUT-IN]
Using menu
OUTPUT TIMING
→
OUTPUT FADE OUT-IN
For
Each output connector (OUT1 to OUT32)
Set value
ON
:
ON (switching effect) [Default]
OFF
:
OFF (no switching effect)
【
NOTE
】
Channels that do not have a scan converter output slot board cannot be selected in this menu.
8.6.11 HDCP output [OUTPUT HDCP]
Please set
“AUTO” normally. If “AUTO” is set, FDX does not output HDCP until input channel which has
HDCP is selected. Once input channel which has HDCP is selected, FDX outputs HDCP always after the
selection.
If
“INPUT ONLY” is selected, FDX outputs HDCP only if input signal has HDCP. However, some sink devices
may fail HDCP authentication sometimes when signal changes from HDCP OFF to ON and not output video
and audio temporary.
If sink devices which do not support HDCP are connected, FDX outputs signal which does not have HDCP
regardless this menu.
Using menu
OUTPUT TIMING
→
OUTPUT HDCP
For
Each output connector (OUT1 to OUT32)
Set value
AUTO
:
Do not output HDCP until input channel which has HDCP is selected [Default]
INPUT ONLY
:
HDCP is output only if input signal has HDCP.
【
NOTE
】
Channels that do not have a scan converter output slot board cannot be selected in this menu.