Part 2 - Configuration
44
Remote Control
•
Port
: Select
None
,
RS232
or
RS485
and then
click
the Setup button and then select the correct
Baud
Rate
,
Parity
,
Data Bits
and
Stop Bits
for the device
you are connecting to the DVR. You can select the
device from the
Remote Control Product
list. If the
RS232
port and
RS485
port are in use for PTZ control,
networking or text input, the remote keyboard cannot
be configured. In this case, the warning message
window will appear when other devices use the same
port such as PTZ control, networking or text input.
The message says that you cannot use other device
because the ports are overlapped.
Network Setup
Refer to the
for basic
information on using the Setup menus.
General
•
Multi Stream:
Supports more than one stream.
Configure to use different streams in layout mode or
channels in IDIS Center Client.
During playing, the transfer speed can be low.
•
bps/ips:
Select the Transfer Speed from 1Mbps to
100Mbps and the unit of measure for the transfer
speed between: bps and ips. The available value
differs depending on the quality and resolution
settings.
•
Quality:
Select the Quality from: Very High, High,
Standard and Basic.
•
Resolution:
Select the Resolution from: Very High,
High and Standard.
The higher Quality and Resolution settings require
higher Transfer Speed settings. The transfer speed you
set is the maximum speed. Depending on the network
environment, this speed may not be achieved.
