Part 2 - Configuration
70
Video-Analytics_Trip Zone
●
No.
: Select which cameras to apply Trip Zone to.
●
Zone
: Define the motion detection block.
Use the remote control’s arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the
Camera
buttons.
You can use the mouse to drag the zone and then select,
clear, or reverse the selection.
From the zone selection screen, press the
button
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
–
Select
: Confirm the block selection in the selection
window.
–
Clear
: Clear the block selection in the selection
window.
–
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
–
Select All
: Select all blocks.
–
Clear All
: Clear all block selections.
–
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
–
Trip Direction
: Define in which direction the
motion has to occur in order for it to be considered
an event. Select In for movements from outside the
selection area in or Out for movements from inside
the selection area out.
–
OK
: Save the changes and exit the menu.
–
Cancel
: Exit the menu without saving the changes.
●
Setup
–
Sensitivity
: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
–
Ignoring Interval
: The system does not produce
event log entries or remote notifications for
events detected within a certain period of time
after Tripzone events of the camera channels are
detected. Set a value between 1 sec and 5 secs or
choose Never.
Trip Zone Ignoring Time does not affect Trip Zone
recording.
