Operator Manual
Aspect 100T
L100-3063 REV A
8
SETUP
Unpack
No special handling is required for unpacking this equipment at the site. Conventional shipping materials
are used.
To remove the table from the shipping pallet, roll the table down a temporary ramp or lift off pallet with a
forklift. When using a forklift, pad the forks to protect the paint. Lift from under the metal base. When
rolling the table off the pallet by hand, grip the handles attached to the tabletop to guide the table after
releasing the caster brakes.
Install
Mobile tables are equipped with four locking caster brakes. Unlock brakes while positioning.
Hand controls are standard with this table with foot controls as optional. The operator should become familiar
with the controls before using.
The table operates on 110Vac (or 230Vac) or on internal battery backup. Plug the power cord into a properly
grounded hospital grade outlet. The green indicator will illuminate. The green indicator can be seen through the
port in the large side cover.
The outlet used should be visible and accessible to the user. The cord should be routed where it will not be subject
to damage or be a hazard. Check that the power cord ground pin is in good condition. Check that the cord ground
wire is securely connected to the ground stud inside the unit.
During an AC failure, the table will automatically run on battery backup without any manual switching required.
It is recommended that power be applied at all times, even when not in use, to keep a proper charge on the
batteries and achieve maximum battery life. (Batteries are being charged during normal use).
Where the integrity of the external protective earth conductor is in doubt, this equipment shall be operated from its
internal electrical power source by unplugging the power cord from the mains.
Recycle or dispose of shipping
material per local regulations.
