Operator Manual
Aspect 100-4T and ISR
L100-2843 Rev. E
2
OVERVIEW
An Aspect 100-4T or Aspect ISR along with any accessories shall be referred to in this manual as “this
equipment.” This manual is not intended as a substitute for certified training for the use of this equipment.
The operation of this equipment should be limited to qualified medical personnel who have been trained in
the use of medical equipment.
The text of this manual was originally written, approved and published by the manufacturer in English.
This equipment complies with applicable FDA performance standards contained in 21CFR at date of
manufacture.
OWNER RESPONSIBILITIES
The owner of this equipment is responsible to ensure system compatibility, the qualifications of operators and
maintenance personnel. Operators must be properly trained and have obtained credentials from the
appropriate authorities.
This equipment must be installed in an area provided with the proper electrical power.
The owner of this equipment is responsible for verifying continued compliance with all applicable regulations
and standards. Consult local, state, federal and/or international agencies regarding specific requirements and
regulations applicable to the use of this equipment.
Image Diagnostics, Inc. certifies only this equipment. Operating practices and safety for this equipment are
the sole responsibility of the owner and operators. Image Diagnostics, Inc. assumes no liability or
responsibility for personal injury or damage resulting from misuse of this equipment.
Never make modifications or adjustments to this equipment unless directed by a qualified Image Diagnostics
representative. This equipment, when properly manufactured, meets US federal regulations and international
standards. Unauthorized modifications to this equipment may impact adherence to these standards and make
this equipment unsafe to operate.
CUSTOMER SUPPORT
Image Diagnostics, Inc. may provide on request circuit diagrams, component part lists, calibration
instructions, or other information to assist the user’s appropriately qualified technical personnel to repair those
parts of equipment which are designated by the manufacturer as repairable.
For technical assistance, call IDI at (978) 829-0009. Be prepared to give the complete model
and serial number found on the data plate on the table base at the time of contact.
