Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
10
Triangulation Bars and rail clips until the 6ft.-8in. The rails are spaced 17-1/8in. apart at both
ends of the rails as shown in Figure 3.
5.
Tighten rail clip hardware using Loctite #242 or equivalent.
INSTALL RAIL X/Y STOP
1.
The X/Y stop unit should have a T-nut fastened to it with two socket head cap screws. Loosen
the screws for the T-nut and insert the X/Y Stop unit’s T-nut into one end of the IDI Cross Rail
nearest to the opposing system in the room. See Figure 4 for correct orientation.
Figure 4
2.
Hand tighten screws until the system is fully installed and the final position of the stop is known
then tighten using Loctite #242 or equivalent.