MT-50 Multitouch Table DIY Building Instructions–Version 1.2 - 4/5/11 - Page 19
With the mantle placed in the aluminum frame without the glass, mark
precisely where the holes on the inside of the mantle are on the aluminum
strut. After you have marked those holes, remove the mantle and place
8mm T-nuts with an M4 hole exactly where you made the marks. To hold
the T-Nuts in place, you can wedge some masking tape around the nut.
Once the tape is applied and the T-nuts are placed into the aluminum
frame, you are ready to place the glass in. This will take 2 or 3 people.
Place the two shorter pieces of the mantle into the frame. Place the glass
into one end, and rest that end in the aluminum frame. Lift the other side
of the glass up and place the other short piece on the glass. Lift the entire
piece of glass out, and place the two longer pieces of the mantle on the
glass, and lower the entire construction into the aluminum frame. Once it
is in, secure the top mantle with M4 screws into the T-nuts that were
placed into the frame previously.
Содержание MT-50
