IDEAL TILT-A WAY HYJG 1, Руководство оператора и каталог запасных частей

Страница: 48 / 131

EMX Industries, Inc. Tech support: 216-834-0761 3/6
ULT-PLG_Rev1.8_082619 technical@emxinc.com
Automatic
Sensitivity
Boost
DIP Switch 8
The Automatic Sensitivity Boost causes the sensitivity
to increase following initial detection. This feature is useful
to prevent dropout when detecting high-bed vehicles.
The sensitivity returns to its normal setting after the vehicle
exits the loop. The decimal point on the ULTRAMETER
™ display
indicates ASB is on.
ASB Enabled on
ASB Disabled off
Presence DIP Switch 7 Infinite
presence mode causes the output to remain in detect
as long as the vehicle remains on the loop. Normal presence
mode causes the output to reset after 5 minutes. Do not use
Normal presence mode for reversing loop applications.
Normal on
Infinite off
Detect-On-Stop ™ DIP Switch 6
The Detect-On-Stop ™ (DOS
®
) feature requires that a vehicle
must come to a complete stop over the loop for a minimum of
1-2 seconds before Output B activates. DOS
® will not function
if in Loop Fault mode. Do not use DOS ® feature for reversing
loop applications.
DOS ® On on
DOS ® Off off
Output B DIP Switch
Output B is configurable for four possible modes.
In
Pulse on Entry/Exit mode, Output B will be activated for
approximately 500ms when a vehicle is entering or exiting
the detection zone. In
B same as A , relay B has the same
output as relay A. In Loop Fault mode, the relay will trigger
if a loop fault occurs.
Mode 5 4
Pulse on Entry on on
Pulse on Exit on off
B same as A off on
Loop Fault off off
Fail Safe / Secure DIP Switch 3
The Fail Safe setting causes the ULT-PLG to activate the
presence output in the event of a loop failure. The Fail Secure
setting will cause the ULT-PLG not to activate the presence
output in the event of a loop failure.
Do not use Fail Secure
for reversing loop applications.
Fail Safe on
Fail Secure off
Frequency
Settings
DIP Switch
DIP switches 2 and 1 are used to assign the loop operation
frequency. The primary purpose of the
Frequency Setting
is to allow the installer the ability to set different operating
frequencies for multi-loop installations and is recommended
to prevent crosstalk/interference from multiple loops.
2 1
Low on on
Medium Low on off
Medium High off on
High off off