IDEAL FAST-WAY Si-Low 210 A1, Руководство пользователя

Страница: 95 / 149

Operation & Maintenance Manual
7
Cyclo® BBB4
Cyclo® BBB4
Installation Notes
Installation Precautions
• Do not use the reducer/gearmotor for specifi cations
other than those shown on the nameplate or in the
manufacturing specifi cation documents. Personal
injury and/or equipment damage may occur.
• Do not place combustible material on or around
the unit; fi re may occur.
• Do not place any objects around the unit that will
prohibit proper ventilation. Inadequate ventilation
may lead to high unit temperature and/or fi re.
• Do not step on or hang from the unit. Excessive
weight may cause component breakage leading to
personal injury and/or equipment damage.
• Do not touch the shaft, keyway, or motor fan with
bare hands; injury may occur.
• For applications in which lubricant leaks could
adversely aff ect operations (i.e., package handling,
food processing), place an oil pan below the unit to
protect against contamination that may occur if oil
seals become damaged or worn.
• Do not remove the eye-bolt from the motor. Should
the eye-bolt need to be removed for any reason,
install a replacement bolt in the tapped hole to
prevent water from entering the motor.
Installation Location
Ambient Temperature Range: 14° - 104°F
(-10
°
- 40°C)
Ambient Humidity: 85% or less
Ambient Conditions: 14°F minimum
Altitude: 3,280 feet
(1,000 m)
or less
Atmosphere: The location should not contain
corrosive gas, explosive gas, or
steam. The location should be free
of dust and well ventilated.
Location: Indoor – free of dust and water
Consult Sumitomo when the unit will operate in conditions other
than those specifi ed above. Special unit modifi cations may be
required.
Units manufactured according to customer specifi ed application
requirements (i.e. outdoor modifi cations, high-temperature
modifi cations) are designed to operate within the specifi ed
environment.
Install the unit so inspection and/or maintenance procedures may
be easily performed. Install all units that are not shaft mounted
on a suffi
ciently rigid base.
Torque arm clearance with machine structure is required to allow
for machine shaft run out. Refer to the Torque Arm Installation
section in this manual for additional information.
Installation Angle
Mount the unit in the specifi ed position for which it was
ordered. Confi rm the mounting position from the gearbox
nameplate.
Consult your local distributor, Original Equipment Manufacturer
or Sumitomo directly if the mounting angle is to be
other than
horizontal or vertical.
Severe Loading Conditions
For applications with severe vibration and/or frequent starts and
stops, Sumitomo recommends the use of high-strength mounting
bolts of Grade 8.8 (or greater).
Installation onto the Driven Machine
• Before coupling the reducer/gearmotor to the
machine, verify the appropriate/desired rotation of
the machine. Diff erences in the rotational direction
may cause personal injury and/or equipment dam-
age.
• Before operating the unit, ensure that all safety
guards around the rotating components are
in-place and secure. Failure to do so may result in
personal injury.
• When joining the reducer or gearmotor to the load,
ensure that the center alignment, belt tension, and/
or parallelism of the coupling device are within the
coupling manufacturer’s established recommendations.
For applications with a belt, ensure that the belt is
properly tensioned to the manufacturer’s specifi cation,
and the bolts securing the pulley and couplings
are suffi
ciently tightened. Failure to follow these
precautions may result in personal injury and/or
equipment damage.