www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
install guide
Version française disponible en ligne au www.idatalink.com
doorlock interface
chrysler / dodge / Jeep
Page 5 of 11
ADS-DLSL-CH1
20071214
www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
NOTICE:
the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. please review the installation guide carefully before beginning any work.
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
BLUE (IG)
YELLOW (S)
VIOLET/BROWN (SWITCH MUX*)
KEY
LOCK (-) INPUT - GREEN/BLACK
UNLOCK (-) INPUT - BLUE/BLACK
TRUNK (-) INPUT - RED/WHITE
(NC) BROWN
LEFT SLIDING DOOR (-) INPUT - VIOLET/YELLOW
RIGHT SLIDING DOOR (-) INPUT - VIOLET/BLACK
(NC) WHITE
(NC) BLACK/WHITE
TRUNK & DOOR STATUS (-) OUTPUT - GREEN
TACH OUTPUT (AC) - VIOLET/WHITE
BROWN/RED (NC)
BROWN/YELLOW (NC)
ORANGE/BLACK - GROUND
ORANGE/WHITE (NC)
ORANGE - DATA (J1850)
PINK/BLACK (NC)
PINK - IGNITION (+) INPUT
YELLOW/BLACK (NC)
YELLOW/RED (NC)
YELLOW - ANALOG OUTPUT
VIOLET/GREEN
GROUND-OUT WHEN RUNNING (-) - BLUE/WHITE
(NC) WHITE
GROUND - BLACK
12V - RED
REMOTE
STARTER
OR
SECURITY
SYSTEM
OR
KEYLESS
ENTRY
*Use isolated ground-out
when running from remote
starter to power relay.
RESISTOR
BETWEEN 180-210 0HMS
85
30
87
87A
86
***** OPTIONAL *****
TRANSPONDER LOOP
ADS-RNG-C1 IS REQUIRED
FOR TRANSPONDER BYPASS
APPLICATION.
CONNECT TO PIN #2 OF OBDII
CONNECTOR LOCATED UNDER
DRIVER SIDE DASHBOARD
BCM IS LOCATED UNDER DRIVER’S SIDE
DASH AGAINST FIREWALL.
IDATALINK (RS232) PORT
REQUIRED ON REMOTE STARTER.
IF THE PORT IS UNAVAILABLE
USE STANDARD WIRING METHOD.
LEGEND
Wiring connections not required
when installed in iDataLink mode
IDATALINK
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
C1
C2
C3
C4
C5
1
9
26
34
C3
TYPE 4
wIrINg DIAgrAM
Num. de Doc.: ##00130##
