49
6.
6. Secure the driver in the rack using two
mounting screws in both the
side-mounting holes. Please don’t
tighten the screws too much, as that
may damage the driver.
7.
8.
7. Screw the rack into the device, fixing in
all the four screws.
8. Attach the interface connector and the
power connector to the drive. Please
note the red lining of the IDE cable and
the red wire of power cable must line up
side by side.
10.
Place the mobile rack back onto the device and screw it in.
7.2 Mobile Rack
1.
2.
1. Make sure that the key is unlocked.
2. Pull the active-handle outward to
detach the carrier body away from the
mobile rack
3.
4.
3. Slide the top cover backward and
remove.
4. Setting the jumper of your hard disk
driver: the way to set the jumper of the
drive varies between manufacturers;
please refer to the instructions on the
driver to set the jumpers in the master
position.
