LAPTOP TRAY ARM INSTALLATION
• Remove small socket head cap screw in the top
center of the Wall Track. Remove plastic cover.
• Locate the wall stud and mark the top hole of the
Wall Track.
• Drill 11/64 pilot hole, insert #14 screw and tighten
slightly. Use a level, mark the lower holes, drill
pilot holes and then insert the #14 screws.
NOTE: #14 Wood screws are supplied with unit. If installing into
metal studs, you will need to replace these with proper metal
stud fasteners
MOUNT ULTRA TRACK TO WALL
LAPTOP TRAY ARM INSTALLATION - 6/1/20
IF MOUNTING
TO THE WALL
IF MOUNTING TO THE
ULTRA WALL TRACK
ATTACH ARM TO MOUNT
MANAGE CABLES
Follow instructions below
for your style of mount.
Follow instructions
on next page.
IMPORTANT:
DO NOT flip up tray when laptop is placed on it.
ATTACH QUICK DISCONNECT
• Remove beauty cap on
Quick Disconnect block.
• Remove screw using
3/16” hex key.
• Slide keyboard tray into
Quick Disconnect block.
• Replace screw and
tighten.
• Replace beauty cap.
LAPTOP TRAY ARM INSTALLATION
MOUNT ULTRA TRACK TO WALL
• Remove small socket head cap screw in the top center
of the Wall Track. Remove plastic cover.
• Locate the wall stud and mark the top hole of the Wall Track.
• Drill 11/64 pilot hole, insert #14 screw and tighten slightly. Use a level,
mark the lower holes, drill pilot holes and then insert the #14 screws.
NOTE: #14 wood screws are supplied with unit. If installing into metal studs you will
need to replace these with proper metal stud fasteners or the provided snap togglers.
All hardware used to secure track mount must have a proper countersunk head.
Beauty cap
Screw
ATTACH SLIDER TO ULTRA TRACK
• Insert slider into wall track.
• Replace the plastic cover
and small socket
head cap screw.
Once you have adjusted the
slider to the desired height,
tighen down the Track Slider
using the knob on the slider
as shown.
Adjust slider to desired height. Tighten slider using adjustment knob.
ADJUST SLIDER POSITION
STANDARD
INVERTED
ATTACH WALL PLATE TO WALL
W2
Locate the stud and mark
the top hole, drill 11/64
pilot hole and insert #14
screw and tighten slightly.
Using a level, mark the
lower hold and drill pilot
hole, insert #14 screw
and, with the unit level,
tighten both screws.
NOTE: ICW supplies
#14 wood screws. If
installing onto metal
studs, you will need
to replace with proper
metal stud fasteners.
W3
