Protege DIN Rail 8 PGM Output Expander
| Installation Manual
9
4
Mounting
The Output Expander is designed to mount on standard DIN Rail either in dedicated DIN cabinets or generic
DIN Rail mounting strip.
When installing the Output Expander ensure that there is adequate clearance around all sides of the device and
that air flow to the vents of the unit is not restricted. It is recommended to install the Output Expander in a
location that will facilitate easy access for wiring. It is also recommended that the Output Expander is installed in
electrical rooms, communication equipment rooms, closets or in an accessible area of the ceiling.
1.
Hook the lower tabs under the bottom edge of the DIN Rail.
2.
Push the Output Expander against the DIN Rail mount until the upper tab clips over the upper rail.
4.1
Removal
The Output Expander can be removed from the DIN Rail mount using the following steps:
1.
Insert a flat blade screwdriver into the hole in the tab at the top of the Output Expander.
2.
Lever the tab up and rotate the unit off the DIN Rail mount.
