ICT Protege EliteSuite, Руководство пользователя

Страница: 12 / 20

12
ELT-KLED Protege EliteSuite Icon LED Keypad | November 2013
Instant Arming Your System
During the EXIT DELAY press and hold the key for 2 seconds. The system will instant arm all zones, any zone
will trigger the alarm immediately.
Fast Stay Arming
To fast stay arm your system press and hold the [STAY] key for two seconds.
Switching From Stay to Regular/Force Armed
If you need to leave your premises and want to arm the system fully you can use the fast exit arming method.
Press and hold the [FORCE] key or [ARM] key to switch to exit delay and arm in either force or regular arming.
Force Arming
Force Arming allows you to rapidly arm the system without waiting for all zones in the system to close. During
force arming, a forced zone is considered deactivated until it closes, then the system will arm that zone. Force
arming is commonly used when a motion detector is protecting the area occupied by a keypad. For example,
when arming and the motion detector is programmed as a force zone, the system will allow you to arm even if
the zone is open.
Force Arming Your System
1. Check that all zones that are not force zones are closed and ready to arm.
2. Press the [FORCE] key then enter your [USER CODE].
3. The exit delay will start.
To fast force arm your system press and hold the [FORCE] key for two seconds. This option must be enabled
by your property manager or installation company.
Bypassing Zones
Bypassing zones allows you to program the alarm system to ignore (deactivate) specified zones the next time
the system is armed. For example, you may wish to bypass certain zones when workers are renovating part of
your establishment. Once the system is disarmed, the bypass settings are erased.
Bypassing Zones
1. To select the zone(s) to be bypassed, press the [BYPASS] key and enter your [USER CODE]
The BYPASS LED turns on
2. Toggle bypass mode on by pressing the number corresponding to the required zone.
The zone LED will be lit for each bypassed zone.
3. Press the [ENTER] key to store the bypass settings and exit or press the [CLEAR] key to exit without making
changes.