ICT Protege EliteSuite, Руководство пользователя

Страница: 11 / 20

ELT-KLED Protege EliteSuite Icon LED Keypad | November 2013
11
Arming/Disarming
To take full advantage of your system, you should familiarize yourself with the different arming methods.
Exit Delay
After entering a valid arming sequence, the exit delay time will provide you with enough time to exit the
protected area before the system arms. The keypad will generate a beep-beep tone repeatedly during the exit
delay period. The tone will increase in frequency to indicate that only ten seconds remains.
Disarming
To disarm an armed system or an alarm, enter your user code. An entry point, like the front door, will be
programmed with an entry delay time. When an entry point is opened, the keypad will emit a continuous audible
tone until you disarm the system. The system will not generate an alarm until this timer elapses. All user codes
can be used to disarm the system.
Deactivating Alarm
To deactivate an alarm, enter your [USER CODE]. This will also disarm the system if it was armed.
Disarming Your System
1. Enter through a designated entry point (Entry Door), the entry delay time will start and the keypad will emit a
continuous audible tone.
2. Enter your [USER CODE].
Regular Arming
Regular arming arms your system.
Arming Your System
1. Check that the system is ready to arm and all zones are closed (Ready Indicator is green).
2. Enter your [USER CODE].
3. The exit delay will start and you can now leave your premises.
Quick arming can be used by pressing and holding the [ARM] key. This option must be enabled by your
property manager or installation company.
Stay Arming
This method allows you to remain in the protected area while partially arming the system. Stay zones are zones
that are bypassed when the system is stay armed. For example, when you go to sleep at night, doors and
windows can be armed without arming other zones like motion detectors.
Stay Arming Your System
1. Check that all zones that are not stay zones are closed and ready to arm.
2. Press the [STAY] key then enter your [USER CODE].
3. The exit delay will start.