ICT ICT180-12IRC, Инструкция по эксплуатации, Страница: 16 / 24

Send E-mail: If this box is checked, an e-mail alarm notification will be sent when an output fuse is
blown. The e-mail settings on the Network Setup page must be configured correctly before e-mail
notifications can be sent.
SYSTEM UNDER-VOLTAGE ALARM
Under-Voltage Threshold: If the system voltage drops below the value in this field, the system under-
voltage alarm will trigger.
Under-Voltage Recovery: If the system voltage rises above the value in this field, the system under-
voltage alarm will clear. The value in this field must be at least 0.25V higher then the Under-Voltage
Threshold.
Note: If Load-Shedding Auto-Recovery is enabled on the Basic Setup page, be careful not to set the
Under-Voltage Threshold and Under-Voltage Recovery values too close together. Depending on your site
setup, the system voltage may rise slightly after outputs are disabled. If the system voltage rises above
the Under-Voltage Recovery value as soon as the outputs are disabled, the outputs will be re-enabled
prematurely.
Activate Alarm Form C Contact: If this box is checked, the Alarm Form “C” Contacts on the panel will
indicate a fault condition when the system under-voltage alarm is triggered.
Send E-mail: If this box is checked, an e-mail alarm notification will be sent when the system under-
voltage alarm is triggered. The e-mail settings on the Network Setup page must be configured
correctly before e-mail notifications can be sent.
SYSTEM OVER-VOLTAGE ALARM
Over-Voltage Threshold: If the system voltage rises above the value in this field, the system over-
voltage alarm will trigger.
Activate Alarm Form C Contact: If this box is checked, the alarm form “C” contacts on the panel will
indicate a fault condition when the system over-voltage alarm is triggered.
Send E-mail: If this box is checked, an e-mail alarm notification will be sent when the system over-
voltage alarm is triggered. The e-mail settings on the Network Setup page must be configured
correctly before e-mail notifications can be sent.
SYSTEM OVER-CURRENT ALARM
Over-Current Threshold: If the total system current rises above the value in this field, the system
over-current alarm will trigger.
Activate Alarm Form C Contact: If this box is checked, the alarm form “C” contacts on the panel will
indicate a fault condition when the system over-current alarm is triggered.
Send E-mail: If this box is checked, an e-mail alarm notification will be sent when the system over-
current alarm is triggered. The e-mail settings on the Network Setup page must be configured
correctly before e-mail notifications can be sent.
14