User Guide
3
Before You Begin
Before you can install the USB Rover, you need to prepare your site.
1. Determine where the host computer is to be located and set up the
computer.
2. Determine where you want to locate the USB device.
Installing the LEX unit
1. Place the LEX unit near the host computer.
2. Plug the Type A connector from the LEX unit into the USB port on
the computer.
Installing the REX unit
1. Place the REX unit near the USB device.
2. Plug the AC adapter into an available AC outlet. Connect the DC
power cord to the REX unit.
Completing the Installation
1. Switch on the computer and check that the AC adapter is powered
on.
2. Depending on the operating system you are using, open the Device
Manager dialog box.
3. Expand the entry labeled Universal Serial Bus Controllers.
4. In the expanded entries you should find one for a Generic USB
Hub.
Connecting a USB Device
1. Install any software required to operate the USB device. Refer to
the documentation for this device, as required.
2. Connect the USB device to the USB port on the REX unit.
