14
Step 2 Connect alarm output device to the alarm output port of I/O port cable.
N1 and C1 or N2 and C2 form a switch, which is shown in Figure 2-6, the switch is used to
provide alarm output. Generally the switch is opened; the switch will be closed when there is
alarm output.
Figure 2-6
Step 3 Log in WEB interface, make corresponding settings upon alarm input and output on the
interface of alarm setup.
Alarm input of WEB is corresponding to the alarm input of I/O port cable. It is to set
corresponding NO, NC input according to the high and low level signal generated when
alarm happens for alarm input device.
Set alarm output on the WEB, alarm output is corresponding to the alarm output end, which
is the alarm output port of the I/O port cable.
3 Network Configuration
You can initialize the device and modify IP address via "Quick Configuration Tool"; you can also
initialize device and modify IP address on the WEB interface. Please refer to the
WEB Operation
Manual
in the disk for more details.
Note
It needs to implement initialization if it is the first time use device or the device is restored to
factory default. Only some device support initialization function.
It can implement initialization only when the device IP address (192.168.1.108 by default)
and the IP address of PC are in the same network segment.
In order to make the camera have access to network smoothly, please plan available IP
segment according to the actual network environment.
The following figures are for reference only; different models may have different interfaces.
3.1
Device Initialization
Step 1
Double click "ConfigTool.exe" and open quick config tool.
Step 2
