7
Step 5
Adjust the lens to the needed angle according to the application requirements of the location.
Hold the screw location of the rotation bracket on both sides, turn the rotation bracket horizontally,
adjust the lens direction horizontally to the targeted position; unscrew the two locking screws on both
sides (do not remove them completely, just make them loose), hold the IR light decoration cover to
make the lens rotate vertically, adjust the vertical direction of lens to a proper monitoring angle, then
tighten the locking screws on both sides; Hold the IR light decoration cover to rotate horizontally,
adjust the image and adjust the lens horizontal direction to the targeted location; Range of adjusting
lens angle: vertical (0
°～
+65
°
), horizontal (0
°～
+355
°
).
Figure 2-2
Step 6 Take up the dome enclosure; aim the location of side cable exit and cover the enclosure, use
inner hex wrench to secure three camera screws firmly. So far, the installation is completed.
Side Wiring
When cable installation adopts side wiring, it needs to pull out the plastic decoration plug on the lateral
side of the device pedestal, and then the cable can be pulled out through the lateral side of the
pedestal.
Cable Connection
The device reserves two wiring holes, and supports the pin whose diameter is less than 15mm to pass.
The device is equipped with two waterproof sealing plugs. The waterproof sealing plug can be used to
block wiring hole and threading, which supports the cable whose diameter is between 4.0mm ~ 6.0mm
to pass. It also makes it convenient for the users to operate waterproof work for leading wire by
themselves.
Please refer to the following steps for the exact use:
Step 1
Take out the waterproof sealing plug, and pull the cable with 4.0mm~6.0mm diameter through the
sealing plug according to the direction shown in the following figure.
