ECAN-240-FD (Modbus TCP to 2-port CAN FD Gateway) User Manual
Version 1.0.0
Page
：
31
Copyright © 2022 ICP DAS Co., Ltd. All Rights Reserved E-mail: [email protected]
Item
Description
IP Address
Address Type
Static IP:
If no DHCP server is installed on the network, the network
settings can be configured manually. Refer to
for more details.
DHCP:
The Dynamic Host Configuration Protocol (DHCP) is a
network application protocol that automatically assigns an IP address
Section 4.4.1.2 Dynamic Configuration
for
more details.
Static IP Address
Each ECAN-240-FD connected to the network must have its own
unique IP address. This parameter is used to assign a specific IP
address.
Subnet Mask
This parameter is used to assign the subnet mask for the
ECAN-240-FD device. The subnet mask indicates which portion of the
IP address is used to identify the local network or subnet.
Default Gateway
This parameter is used to assign the subnet mask for the
ECAN-240-FD device. The subnet mask indicates which portion of the
IP address is used to identify the local network or subnet.
MAC Address
This parameter is used to set a user-defined MAC address, which
must be in the format FF-FF-FF-FF-FF-FF.
Modbus Settings
Modbus Net ID
This parameter is used to configure the Modbus NetID.of this module
Default value: 1
Command Port
This parameter is used to configure the Modbus TCP Command Port
to a custom value depending on your requirement.
The default Modbus TCP Command Port is 502
Command Port
Timeout
(Socket Watchdog)
If the command port does not receive any data from the TCP/IP
socket for a certain period, the ECAN-240-FD can disconnect the
socket.
Settings range value: 1 ~ 65535 (seconds);
Default value: 180 (seconds); Disabled: 0;
Update Settings
Click this button to save the revised settings to the ECAN-240-FD.
All settings will take effect after rebooting the device.
