Page 11
The Main Operating Screen
(above left)
appears when you touch the
WELCOME
screen. It provides many options
which are covered in detail later in this manual,
To quickly start the system you can simply accept the automatically inserted water temperature setting of
15ºC
.
The two most commonly used temperatures for ice bath sessions are pre set for your convenience.
15ºC
is inserted
automatically on start up and you can just accept this and continue. If you choose “
Change Settings
” then the
Temperature Selection Screen
appears (top right) and
10ºC
is automatically set.
If you require a different temperature
then after touching the
“Change Settings”
button, the screen will change to
the
Temperature Selection Screen
with
10ºC
will be inserted automatically. Then
you have the option of changing to any temperature you require by simply touching
the up and down arrow buttons.
As you make changes the new pool water temperature setting will appear on the
bottom left-hand of the screen in the blue window marked
”Selected Temperature”
.
The right-hand side of this screen shows the outside air temperature.
Once the pool water temperature you want your iCool to cool to is selected, touch the
“Start”
button (next to the up down arrows). This takes you back to the
Main Operating Screen.
If you did not need to use the Temperature Selection Screen and accepted 15ºC, then you will still be seeing
the Main Operating Screen.
NOTE: The temperatures can also be displayed in Fahrenheit. This is explained on page 14 of this Manual.
STEP 3: Start the Water Pump.
Touch the
”Start Pump”
button. The pump will begin operating and water should begin circulating within
a minute or so.
Please note!
When you touch the main buttons they change from
”Start” buttons
to
”Stop”
buttons
and can then be used to
Stop
that function if required.
Water MUST be flowing correctly before you touch the “Start System” button.
The water flow is pre set to an optimum flow of between 100-200 litres or around 25-50 gallons per minute. This
allows time for the heat exchangers to operate at maximum cooling efficiency and maintains the proper pressure.
Pool water is completely changed approximately every 10 to 15 minutes in a 6 person spa.
Do not touch
the
”Start System”
button until you are sure that water is flowing smoothly.
If water does not flow
smoothly within two to three minutes, please check the plumbing, or if using an optional filtration system check that
there is water in the filter housing and no air trapped. If your pump has a debris filter basket, check the basket.
If water does not flow smoothly after 2-3 minutes the system will sound
an alarm and shut the pump off
. A red
warning screen will appear with information about how to correct the water flow problem.
STEP 2: Select the Required Temperature.
10
27
Main Operating Screen
Temperature Selection Screen
Start