9.
Into the end of each module connect the short 15-conductor ribbon cable. It only goes into the sockets one way and the
cable is reversible. It does not matter which end goes into which module.
Caution: for safety, use only the interconnection cable supplied by Renkus-Heinz.Using a small Philips screw driver, secure
the connector on each end of the ribbon with two 4-40 Philips head screws (supplied). Make sure the connectors are fully
seated. You should hear a click when they seat. If necessary, use a flashlight to check because if the connectors are not
seated properly, you may have to disassemble the column again in order to seat them correctly.
10.
Align the two modules and slide them together, making sure the holes in the heavy joining plate align with the holes in
the modules.
11.
Install the remaining joining plate screws and snug them reasonably tight.
12.
Turn the assembly on its rear and install the small coupling bars.
Note: If you are assembling an IC24A. IC32A or IC32/16A with hinges, verify that the center joining plate with a
hinge on it is located in the best spot for the installation. If it isn’t, now is the
time to move it to another loca-
tion.
7
Owners Manual
