icontrols PULSE 100 Series, Инструкция пользователя

Страница: 10 / 22

10
11
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY OR DEATH, ENSURE THAT THE FOLLOWING
PRECAUTIONS HAVE BEEN FOLLOWED PRIOR TO CONNECTING OPERATOR TO POWER:
WIRING INFORMATION
Applying Power
The Pulse 100 Series Operators do not require a qualified electrician for installation, provided an outlet has
been properly wired and mounted by a qualified electrician within 4 feet of the operator. The operator is
provided with a standard 3 prong power plug - simply insert it into the outlet to apply power.
DO NOT PLUG IN UNIT UNTIL INSTALLATION IS COMPLETED FULLY AND YOU ARE PREPARED TO ALIGN PHOTO EYE
AND SET LIMITS.
Wiring of Peripherals
The Pulse 100 Series Operators can accomodate added reversing devices (Photo-Eyes, Light Curtains,
Reversing Edges, Etc.) and added activation devices (Remote Radio, Floor Loop, Pull Cord, Motion
Detector, Photo Eye, Etc.) across a variety of peripherals - see the wiring diagrams for connection details.
As well, there is an on board relay for interlocking or external communication for signalling devices,
security systems, fire systems, etc.
NOTE: It may be required to drill an added hole into the enclosure for wire access for peripherals. If
doing so, DO NOT DRILL INTO THE PRINTED CIRCUIT BOARD, CLEAN ALL SHAVINGS/DEBRIS FROM INSIDE
THE PANEL and USE APPROPRIATE CONNECTOR FOR CABLE ENTRY.
Battery Connection
The Pulse 100 Series come standard with Built-In Battery Backup that provides 24Vdc/0.8Ah of power for
power-outage situations. To connect the batteries, first mount the batteries to the inside of the enclosure lid
by matching up the applied Tongue and Loop on the batteries with those in the enclosure lid and firmly
applying. Then simply connect the battery wires to the connectors found on the upper left corner of the
board.
1. Ensure that a 15A (min.) outlet has been previously installed within 4 foot radius of Operator
by qualified electrician/technician only and meets national and local electrical codes.
2. Outlet should be on a dedicated circuit and properly protected.