13
12
www.iconico.es
User manual WC3
5.1 Remote control installation
Remote control hanger installation (drilling)
2. Put the expansion tube into the wall hole
and the hanger is tight against the wall.
Align the hole in the hanger with the
expansion tube and tighten the screw, and
then cover with the silicone cap.
Note:
Please do not install and use the product in a moist place, such as a steam room, and never place it
in a place where it could easily get wet.
1. Clean and dry the pre-installed area of
the remote control rack on the wall. (When
determining the installation location, make
sure that the user can reach the remote
while seating on the toilet.
Installation area
.
2. Remove the adhesive tape on the back of
the hanger and place it tightly against the
wall, then cover with the silicone cap.
Remote control hanger installation (adhesive)
1. Place the remote control hanger
upright on the pre-installed area of
the wall and mark the location of the
two mounting holes on the wall with a
marker.
Drill a hole in the marked position
on the wall with a drill bit of 6 mm in
diameter, with a depth of 35 mm.
When determining the installation
location, note that when the person can
reach the remote while seating on the
toilet.
1. Put the batteries into the remote control
and cover it.
2. Place the remote control into the hanger.
PRESSURE
POSITION
REAR/MOVE
FRONT/M
OVE
STO
P
HOLD TO
ECO
DRY
5.2 Remote battery installation
6. Remote operation procedures
Rear cleaning
Front cleaning
Dry operation
• Press [
Rear cleaning/massage
] button, the indicator light is on showing current water
temperature level, it starts rear cleaning.
• Press again [Rear cleaning/massage] button to shift to massage cleaning (nozzle
moves forward and backward to expand cleaning area).
The cleaning will last for a complete cicle and stop automatically, while it will stop
immediately if the user presses [Stop] button.
• Press [Front cleaning/massage] button, the indicator light is on showing the current
water temperature level, it starts front cleaning.
• Press again [Front cleaning/massage] button to shift to massage cleaning (nozzle
moves forward and backward to expand cleaing area). The cleaning will last for a
complete cicle and stop automatically, while it will stop immediately if the user presses
[Stop] button.
• Press [Dry] button, the indicator
light is on showing the current water
temperature level, it starts drying; it will
stop drying automatically after a cicle or
when the user leaves the seat.
PRESSURE
POSITION
REAR/MOVE
FRONT/MOVE
STOP
HOLD TO ECO
DRY
Rear
Front
Dry
