19
18
www.iconico.es
User manual WC3
7. Daily maintenance
Main unit maintenance
Spray nozzle maintenance
3. Use only a soft, damp cloth to clean.
Avoid using harsh chemicals.
DO NOT pull the nozzle housing outward or
inward to prevent damage of the nozzle and
motor.
4. Once cleaning is completed, re-install
the nozzle to the nozzle housing. Press
the [Stop] button on the main unit/remote
control to return the nozzle rod to its normal
position.
Note:
In this state, the nozzle rod will return
to its normal position if sitting on the unit or
no operation for 10 minutes.
3. Safety self-inspection
• After cleaning, re-connect the toilet with
the power supply.
1. While not sitting on the unit, short
press the [Rear/Move] Button on the
main unit, the spray nozzle will extend
outward and water will flow out.
2. The spray nozzle can be removed
and cleaned separately. After the spray
nozzle extends outward, hold the nozzle
housing with one hand, remove the
nozzle itself by gently pulling it with the
other hand.
1. Disconnect the power before
maintenance.
2. Use only a soft, damp cloth to clean.
Avoid using harsh chemicals.
Filter maintenance
If the spray performance is poor
under normal conditions:
1. Turn off the water supply at the ball valve
switch and disconnect water inlet hose.
General maintenance
When the electronic bidet is working
abnormally and needs to be repaired, the
following steps must be taken first.
1. Drain the water inside the bidet:
• Hold the [Stop] button and press
the [Water temperature] button on the
remote control.
2. Turn off water and power supply:
• Turn off ball valve switch and disconnect
power.
3. Empty residual water in the tank:
• Remove fixing screws of bidet and
then lift the bidet up (refer to installation
manual), remove the drain plug and
ensure water in the tank is completely
emptied.
2. Remove the filter.
3. Clean out filter under running water.
4. Re-install the filter, re-connect water inlet
hose and then turn on water supply.
Note:
DO NOT put the bidet upside down or on its
sides before emptying all water in the tank.
Once water is emptied, reinstall the drain
plug.
Unscrew the drain plug with slotted screwdriver
4. Disconnect water inlet hose and coupler
before the next step of maintenance
