9
ARM ASSEMBL
Y
12. Wet the handle of one Press Arm (46) with
soapy water. Slide a 5Ó Plastic Grip (31) onto
the handle. Press a 1Ó Round Inner Cap (49)
into the other end of the handle. Press a 1
3/4Ó Square Inner Cap (44) into the top of the
Press Arm (46).
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16Ó x 2 1/2Ó
Bolts (22) and two 5/16Ó Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
13. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); note the posi-
tion of the ÒVÓ Pulley (6) to identify the
Right Arm. Be sure that the upper end of
the Right Arm is behind the indicated
bracket on the Top Frame (55).
Tap two 1Ó Retainers (69) and a 1Ó Round
Cover Cap (70) onto the axle.
Be sure that
the teeth on the Retainers bend toward the
Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4Ó Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10Ó Pad (45) onto the
lower end of each Arm.
13
31
44
49
46
46
22
3
17
47
70
45
45
44
69
6
Bracket
12
48
44
70
69
55ÑAxle
55
AxleÐLubricate
16
28. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
HOW TO USE THE HOME GYM SYSTEM, beginning on page 17 of this manual.
Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAM on page 22 of this manual for proper cable routing. If there is any slack in the
cables, the cables should be tightened. See TROUBLE-SHOOTING AND MAINTENANCE on page 21.
