1. De-pressurize and Vent System Prior to Installation or Removal.
2. Confirm Chemical Compatibility Before Use.
3. DO NOT exceed Maximum Temperature or Pressure Specifications.
4. ALWAYS Wear Safety Goggles or Face-shield During Installation and/or Service.
5. DO NOT Alter Product Construction.
If leaking is observed from the retaining cap, it indicates
defective or worn o-rings on the sensor. Do not attempt to
correct by further tightening.
WARNING!
Indicates a potential hazard. Failure to follow all
warnings may lead to equipment damage, injury, or
death
Warning | Caution | Danger
Overtightening may permanently damage product
threads and lead to failure of the retaining nut.
Hand Tighten Only
Failure to follow these instructions may result in
the sensor being ejected from the pipe!
Use of tool(s) may damage product beyond repair
and potentially void product warranty.
Do Not Use Tools
Highlights additional information or detailed
procedure.
Note | Technical Notes
Safety Information
Do Not Remove Under Pressure
Please ensure that the Instruments are not to be subject to water hammer or pressure spikes!
Always Pressure Test System with H
2
O Prior to Initial Start-Up
Before Before installation be certain the appropriate instrument has been selected considering operating pressure, full scale
pressure, wetted material requirements, media compatibility, operating temperature, vibration, pulsation, desired accuracy and
any other instrument component related to the service application including the potential need for protective attachments and/or
special installation requirements. Failure to do so could result in equipment damage, failure and/or personal injury. Ensure only
qualified personnel personnel are permitted to install and maintain this instrument.
Sensor may be under pressure, take caution to vent system prior to installation or removal.
Failure to do so may result in equipment damage and/or serious injury
Pressurize System Warning
TK Series can be installed in a horizontal or vertical direction. Please ensure enough length of straight pipe to avoid turbulence
that can effect readings.
A Bag Filter or Y Strainer Filtering Device upstream to Avoid the Paddle Wheel from being damaged by the solids or fibers
- max 10% Particle Size - Not to Exceed .5mm Cross Section or Length.
Please do not flush the pipe after the Flow Meter is installed with Compressed Air this may damage the ceramic shaft and will
Void Warranty
Please Ensure Full Pipe
Min 10x Pipe Diameters Upstream 3x Pipe Diameters Downstream.
Always utilize the most appropriate PPE during installation and service of Truflo products.
Personal Protective Equipmet (PPE)
www.iconprocon.com | [email protected] | 905.469.9283
03
In-Line Paddle Wheel Flow Meter
TKP
|
TKM SERIES
(Quick Start)
Содержание truflo TKP Series
Страница 12: ......
