ICON ATV08, Руководство пользователя

Страница: 31 / 32

ICON EV Manual Troubleshooting ATV08 31
S/N Failure Cause Eliminating methods
I. Charge the battery fully
II. Replace the governor handle,
controller
I. Replace the governor handle,
controller
II. Re-weld the contact part
I. Weld the connecting line or replace
II. Weld the connecting line or replace
I. Adjust the induced cartridge or
replace
II. Re-connect or replace
I. Tire is full of air
II. The battery is adequate or replace
the charger
III. Replace the battery
I. Low battery voltage
II. Bad governor handle
III. Bad controller
I. Bad governor handle
II. Bad electric door lock and contact
point
III. Bad controller
I. The charger wiring is loose or
damaged
II. The battery weld line falls off or is
damaged
I. The induced cartridge has poor
contact or is damaged
II. The booster wiring is bad or
damaged
I. Tire lacks of air pressure
II. Inadequate charging or failed
charger
III. The battery has been damaged
or its life has expired
IV. Frequent braking startup,
overloading
Failed speed change or too low
maximum velocity
Turn on the power supply, but the
motor does not work
The charger is not charged
The booster has no power assisting
Inadequate mileage of one-time
charging continuation line
1
2
4
5
3