25
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the incline trainer is used.
Replace any worn parts immediately.
Regularly clean the incline trainer and keep the walking
belt clean and dry. First,
press the power switch into
the off position and unplug the power cord.
Wipe
exterior parts of the incline trainer with a damp cloth
and a small amount of mild soap.
IMPORTANT: Do
not spray liquids directly onto the incline trainer.
To avoid damage to the console, keep liquids away
from the console.
Then, thoroughly dry the incline
trainer with a soft towel.
TROUBLESHOOTING
Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed. If further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a.
Make sure that the power cord is plugged into a
properly earthed outlet (see page 12). If an exten-
sion cord is needed, use only a 3-conductor,
14-gauge (2 mm
2
) cord that is no longer than 5 ft.
(1.5 m).
b.
After the power cord has been plugged in, make
sure that the key is inserted into the console.
c.
Check the power switch located on the incline
trainer frame near the power cord. If the switch pro-
trudes as shown, the switch has tripped. To reset
the power switch, wait for five minutes and then
press the switch back in.
SYMPTOM: The power turns off during use
a.
Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b.
Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c.
Remove the key from the console, and then
reinsert it.
d.
If the incline trainer still will not run, please see the
front cover of this manual.
Reset
Tripped
c
MAINTENANCE AND TROUBLESHOOTING
