11
2
INSTALLATION AND CONNECTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
q
Remove the four screws from the corners of the
EX-3187.
w
Unscrew the Sealing Nut from the Sealing tube.
e
Unscrew the inside Nut from the Sealing tube.
r
Remove the five connectors from the board, as
shown below.
t
Remove the cable from the EX-3187’s case.
y
After installing the removed cable at the desired
place, replace the connectors and the Sealing Nut.
■
Removing or connecting the EX-3187’s cable
Sealing tube
Sealing Nut
Washer
Inside nut
Ferrite EMI filter
Ferrite EMI filter
CAUTION:
NEVER cut the display cable or display
extension cable.
NOTE: About Display Cable
The Display cable can also be removed to install
it through a hole in a wall. After installing the cable
through the hole, replace the Sealing Nut in the
same order as described to the left.
To install the display cable though a hole in a wall
where as the display connector cannot pass through
the hole, remove the cable from the EX-3187 or the
Display unit. Then pass it through the hole, as shown
below.
BE CAREFUL! The EX-3187 meets IPX4 require-
ment for splash resistant when the connecting the
connection cables. However, once the unit has been
opened, splash resistance cannot be guaranteed.
