Icom iF610, Инструкция по эксплуатации

Страница: 21 / 36

16
4
OTHER FUNCTION
D D
Call Back function
• If you do not want to answer the call immediately, use this
function.
➥
Pushing [Call Back] will allow you to enable or disable the
function.
• When this function is enabled, the transceiver sends the Call
Back to the called station. “CALL BACK” will be displayed on
the called station’s display, or, when you did not answer the
call or the called station has cleared down before you
answered the call while this function is disabled, the caller’s
number is automatically retained in the memory.
• Up to 15 non-answered calls will be stored.
• When a call is received, the caller’s number is automatically
retained in the memory.
• At the same time, starts blinking to tell the user that there
is the non-answered call stored in the memory.
• will continue to blink until you have answered all the non-
answered calls, or until you have cleared the memory.
• When you push [Call Back] to confirm the memorized con-
tents, stops blinking.
• All the retained non-answered calls are cleared when the
power is turned OFF.
Even if the Call Back function is enabled, calls can be made
normally.
• Call Back
q
If you push [Call Back] when the is blinking or lights,
the memory numbers are displayed.
w
A memory number can be selected using [ ]/[ ].
e
Select a number and then push [PTT]. The selected num-
ber will be dialled to call back.
r
The number called back will be deleted from the memory.
t
You cannot call back to any PSTN or PABX call. The calls
are recorded only.
y
To delete a memory number without calling back to that
number, push [Call Back] and display the number using
the Up and Down keys.
u
Push the [Call Back] key for 2.5 seconds. The number will
be deleted from the memory.
D D
DTMF function
This function allows you to send a DTMF code via the HM-152T
(optional DTMF microphone) while still being able to communi-
cate with the [PTT] switch on the traffic channel.
NOTE: Key pads of HM-152T functions during standby mode
as follows;
• 0 to 9,
✱
and # for dialling.
• A: [P
0
], B: [P
1
], C: [P
2
] and D: [P
3
] of front panel.
IC-F610_F620_MPT_1.qxd 05.8.22 6:07 PM Page 16 (1,1)