Icom iF610, Инструкция по эксплуатации

Страница: 10 / 36

5
2
OPERATION
■
Turning power ON
q
Push to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an
opening message may appear.
w
If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your dealer.
• The keys in the table below can be used for password
input.
• The transceiver detects numbers in the same block as
identical. Therefore “01234” and “56789” are the same.
e
When the “PASSWORD” indication does not clear after
inputting digit codes, the input code number may be incor-
rect. Turn the power off and start over in this case.
‘ ‘ General
Push to turn the power ON. A power-up alert tone will be
heard. Push again to turn the power OFF. The following
information will sequentially appear on the display.
D D
Opening text
The pre-programmed opening text and individual ID will
appear.
The individual ID consisting of a prefix code (3 digits) + a fleet
code (2 an individual code (2 or 3 digits) will appear.
(e.g.) If the prefix code is 200, the fleet code 2001, and the
individual code 300, the individual ID will be ‘2002001300’.
• If you are within the trunking service area, the code (select-
ed by [
]/[ ]) and the received signal strength, are dis-
played to indicate that communication is possible.
*In the “-TEXT-” part, the characters pre-programmed by cloning soft-
ware will be displayed.
• If you are outside of the trunking service area, or if the sys-
tem is down,
will blink.
At this time, the transceiver is searching for any available
system-controlled channel.
KEY [P
0
] [P
1
] [P
2
] [P
3
] [P
4
]
NUMBER 0 1 2 3 4
5 6 7 8 9
(OPENING TEXT)
201 2001 300
-TEXT-
IC-F610_F620_MPT_1.qxd 05.8.22 6:07 PM Page 5 (1,1)