Icom IC-i7410, Инструкция по эксплуатации

Страница: 34 / 124

27
3
BASIC OPERATION
■
Frequency setting (continued)
D Quick Tuning function
The operating frequency can be changed in “kHz”
steps for quick tuning. You can set a tuning step in
each operating mode.
q
Push [TS] to turn ON the Quick Tuning function.
• “
Z
” appears above the 1 kHz digit.
w
Hold down [TS] for 1 second to display the “TS”
screen (Tuning Step).
e
Select a desired operating mode.
r
Rotate [DIAL] to select a tuning step.
• 0.1, 1, 5, 9, 10, 12.5, 20, and 25 kHz are selectable.
• Hold down [F-3] for 1 second to reset to the default set
-
ting, if desired.
t
Repeat steps
e
and
r
to select quick tuning steps
for other modes.
y
Push [TS] to exit the “TS” screen.
NOTE:
• To turn OFF the Quick Tuning function, push [TS]
again.
• When the Quick Tuning function is OFF, the fre -
quency will be changed in 10 Hz steps.
• To display the “TS” screen, the Quick Tuning func -
tion must be turned ON first.
D Selecting 1 Hz step
You can change the frequency in 1 Hz steps for fine
tuning.
q
If the Quick Tuning function is ON, push [TS] to
turn OFF.
w
Hold down [TS] for 1 second to turn the 1 Hz tuning
step ON or OFF.
NOTE:
• When RIT and/or ∂ TX are used, they also tune in
1 Hz tuning steps.
• The frequency changes in 50 Hz steps when the
[UP]/[DN] switches of the microphone are used
for frequency tuning (if the Quick Tuning function
is OFF.)
D
1
⁄
4
Tuning Step function
(Mode: SSB-D/CW/RTTY)
The dial speed is reduced to 1 ⁄
4
of the normal speed
when the 1 ⁄
4
Tuning Step function is ON, for finer tun-
ing control.
q
Push [MENU] to display the “M1” screen (Menu 1).
w
Push [1⁄4](F-3) to turn the 1 ⁄
4
Tuning Step function
ON or OFF.
• “ ” appears when the 1 ⁄
4
Tuning Step function is ON.
1 k H z
S S B
TS
Appears
[TS] [F-3]
Mode selection [DIAL]
[TS]
[DIAL]
A G C T B W S C P
M1
[MENU] [1⁄4]
A G C 1 / 4 S C P
M1
Appears
Appears