Icom IC-7300, Основное руководство

Страница: 20 / 72

3
BASIC OPERATION
3-1
When first applying power
Before turning ON your transceiver for the first time,
make sure all of the following are correctly connected.
• DC power cable
•Antenna
• Grounding wire
• Microphone*
* Different device may be used, depending on the operating
mode.
If all listed above are correctly connected, set
AF RF/SQL
(inner/outer) to the positions described
below.
TIP : When you turn OFF the transceiver, it memorizes
the current settings. Therefore, when you turn ON the
transceiver again, the it restarts with the same settings.
z
To turn ON the transceiver, push
POWER
.
z
To turn OFF the transceiver, hold down
POWER
for
2 seconds until “POWER OFF...” is displayed.
Turning power ON or OFF
Rotate
AF RF/SQL
(inner) to adjust the volume level.
Adjusting the volume level
12 oʼclock position (outer)
Maximum counterclockwise (inner)
About the VFO and Memory modes
Using the VFO mode
VFO mode
You can set the desired frequency by rotating
MAIN DIAL
.
Memory mode
You can enter contents into the desired channel in the
MEMORY list.
Selecting the VFO mode or Memory mode
Push
V/M
to select the VFO or Memory mode.
The IC-7300 has 2 Variable Frequency Oscillators
(VFO), “A” and “B.” Having 2 VFOs is convenient to
quickly select 2 frequencies, or for split frequency
operation (p. 4-10). You can use either of the VFOs to
operate on a frequency and mode.
D
Selecting the VFO A or VFO B
Push
A/B
to select the VFO A or VFO B.
D
Equalizing VFO A and VFO B
You can set the displayed VFO’s frequency to the
VFO that is not displayed.
Hold down
A/B
until 2 short beeps sound.
VFO mode
(Example: VFO A)
Memory mode
(Example: Memory channel 1)
V/M
VFO A VFO B
A/B