8-13
BASIC MANUAL
8
SET MODE
Connectors
» SET >
Connectors
SP Jack Function
(Default: Speaker)
Selects the audio output from the [SP] jack.
•Speaker:
The audio is output from only
the Left channel through the
amplifier for a speaker.
•Phone:
The audio is output from only
the Left channel through the
amplifier for a headphone.
•Phone (L+R): The audio is output from the
Right and Left channels through
the amplifier for a headphone.
Phones Level
(Default: 0)
Sets the audio output level ratio of the
headphone and internal speaker between -15
and +15.
» SET > Connectors >
USB AF/IF Output
Output Select
(Default: AF)
Selects the signal output from the [microUSB]
port.
•AF: An AF signal is output.
•IF: A 12 kHz IF signal is output.
AF Output Level
(Default: 50%)
Sets the AF output level of the [microUSB] port,
when “Output Select” of USB is set to “AF.”
AF SQL
(Default: OFF (Open))
Selects whether or not to output the audio from
the [microUSB] port, depending on the squelch
state, when “Output Select” of USB is set to “AF.”
•OFF (Open): The squelch is always open,
regardless of the transceiver’s
squelch level.
•ON:
The squelch opens and closes,
depending on the transceiver’s
squelch level.
AF Beep/Speech...Output
(Default: OFF)
Sets the Beep and Speech audio output setting
of the [microUSB] port, when “Output Select” of
USB is set to “AF.”
•OFF: The beep and speech audio are not
output.
•ON: The beep and speech audio are output.
IF Output Level
(Default: 50%)
Sets the IF output level of the [microUSB] port,
when “Output Select” of USB is set to “IF.”
» SET > Connectors >
WLAN AF/IF Output
Output Select
(Default: AF)
Selects the signal output to the network.
•AF: An AF signal is output.
•IF: A 12 kHz IF signal is output.
AF SQL
(Default: ON)
Selects whether or not to output the audio to the
network, depending on the squelch state, when
“Output Select” of WLAN is set to “AF.”
•OFF (Open): The squelch is always open,
regardless of the transceiver’s
squelch level.
•ON:
The squelch opens and closes,
depending on the transceiver’s
squelch level.
» SET > Connectors >
MOD Input
USB MOD Level
(Default: 50%)
WLAN MOD Level
(Default: 50%)
Sets the modulation input level of each interface.
DATA OFF MOD
(Default: MIC,USB)
DATA MOD
(Default: USB)
In the SSB, AM, or FM mode, selects the
connector(s) to input the modulation signal
when the Data mode is OFF, or ON.
» SET > Connectors >
SEND Output
HF
(Default: ON)
50M
(Default: ON)
144M
(Default: ON)
430M
(Default: ON)
Selects whether or not to switch the SEND
terminal output level of the [SEND/ALC] jack to
the Low level when transmitting.
•OFF: Does not switch to Low level.
•ON: Switches to Low level.