Icom IC-41S, Инструкция по эксплуатации

Страница: 35 / 56

31
8
OTHER FUNCTIONS
8
■
RX frequency setting
(for RX channels only)
The receive frequency in the RX channels can be re-pro-
grammed within 450 to 520 MHz frequency range depending
on the setting.
D
RX channel setting
The RX channels does not appear on the LCD (default;
“Inhibit” setting) and you cannot select it. So the RX channels
should be set to “Enable” before programming the RX fre-
quency.
q
While pushing and holding
* and *, turn power ON
to indicate all pre-programmed RX channels (including the
inhibited channels.)
w
Select the desired channel with [CH Up] or [CH Down] ,
then push
* to set the displayed channel “Enable.”
e
Turn the power OFF, then ON.
• The “Enable” channels appear on the LCD, and can be selected
with [CH Up] / [CH Down] .
D
RX frequency programming
q
Select the desired RX channel (‘RX-XX’). (See at left)
w
Push [Top]
(Function)
to enter the function mode, then push
and hold [Top]
(RX VFO)
for 2 sec. to enter the RX VFO
mode.
• Push
* to toggle the bandwidth between wide or narrow.
e
Push [CH Up] or [CH Down] several times to select the
desired frequency.
• The frequency changes according to the Wide/Narrow setting.
(p. 33)
*Regardless of the assigned key function.
Narrow channel spacing
(12.5 kHz steps)
Wide channel spacing
(25 kHz steps)
RX VFO mode RX channel
(in function mode)
*Appears when Narrow
channel spacing is set.
“Enable” setting “Inhibit” setting