9
최적의 청소를 위한 참고사항
1
1
2
1/2
3
5
44
MODE
MODE
MODE
MODE
MODE
1
2
3
4/5
6/7
●
Installa
tion
of
robot
cleaner
Check list before cleaning
Install
charging
station
Charging
Insert remote control battery
Two batteries for remote control (alkaline AAA 1.5V) are
included when you purchase this product. Insert batteries before use.
Use the same type of battery once its duration is over.
1. Open the battery cover of the remote control.
2. Check the (+) and (-) pole then push the batteries in.
3. Place the cover properly then push strong until you hear ‘click’ sound.
1. Connect the adapter to the charging station.
2. Make sure to place it on a flat wall and floor.
[Note]
Fix the station with the sticker on the bottom for safer use.
3. No barriers should exist within left/right 0.5meters, front 1.5meters from the charging station.
4. Wind the power cord shown as ①.
5. Connect the power cord and adapter as the picture above.
Status display lamp will appear red on the charging station.
Charging with power off
1. In case the robot cleaner was not used for a long period or the power turned off due
to battery shortage, stick the robot cleaner to the charging terminal of the charging station.
2. Once the robot cleaner is properly placed to the charging station,
the status display lamp will flash as green.
3. Status display lamp will appear green when the charging is complete.
[Note]
Robot cleaner can last for
maximum 90 minutes
when it’s fully charged.
In case the battery is not enough, it takes
about two hours
for re-charging.
