ICI Caldaie MONOLITE JB Series, Техническое руководство

Страница: 17 / 24

MONOLITE
15
5 FITTING THE BOILER CASING
5.1 BOILER BODY INSULATION (Fig. 4-5-6)

Wrap glass wool (A) around the column and attach with the clips.

Wrap glass wool (B) around the upper cylindrical boiler body without covering the shaft/bulb holder located near
the flanged outlet pipe and fix in position with the clips supplied.

Then insulate the rear boiler plate, attaching the wool (C) to the springs on the edge of the plate (see figure).
5.2 BOILER CASING MOD. 45 GT/125 GT – 30 JB/125 JB (Fig. 4)

Fit the panel (1D) by hooking the upper profile to the square tube and the lower to the boiler longheron. Re-
peat the same procedure for panel (1S).

Fit the panel (2D) by hooking the upper profile to the square section tube and the lower to the boiler longheron,
making sure that the side panels are joined by the specific coupling pins. Repeat the procedure for panel (2S) with
the burner-control panel connection cables passing through the aperture (for the wiring harness please refer to
the control panel diagram and to the standard plugs connection kit).

Unwind the thermostat capillaries, fit the control panel (3) to the side (RH or LH), fastening with the screw,
then insert the bulbs in the pocket. Hook the upper rear panel (4) to the sides.

Fasten the support bracket (5) to the frame base L profile; insert the cable grommets in the panel holes (6S),
hook the panel to the side panel and feed through the supply cable, then connecting the cable to the junction
box. Hook on the panel (6D) and then fasten both using the screws at the top, and close the holes with the
specific plugs provided (see figure).

Fix the front/upper panel supports (7) to the boiler plate (excluded JB) and put on the upper panels (8S) and
(8D). Hook on the front/lower panel (9) and the front/upper panel (10). For JB models, hook the front/central
panel (10a) and the front/upper panel (10b). Finally, screw the document holder (11) on to the opposite side of
the control panel (excluded mod. 30/45/75).
Fig. 4