Ice Trike 2012, Инструкция по сборке

Страница: 4 / 15

4
2.2 Unpacking
First of all, open the box, unwrap and lay out
the pieces, inspecting for any damage that may
have occurred during shipping.
The black square of fabric-covered rubber
is not a piece of packaging. Do not throw it
away!!
You should have all the items shown on this
page, as well as any accessories you have
ordered.
Assembling your trike is quite simple, even
if you have done little bicycle assembly/work
before. If you’re uncertain about the work,
any good bike shop will be able to follow these
instructions to assemble it for you.
It will take you an hour or two to put your trike
together, but don’t be tempted to rush through.
Your trike is secured in the box using several
cable ties (zip-ties) which will have to be cut
with a knife, scissors, or snips; be careful not to
cut through the parts or to mark the paintwork.
Have a good look at the various packages and
familiarize yourself with the various parts. In
addition to the main components shown
below, there are other small packages of parts.
Don’t open them just yet; leave them sealed
until you need them.
(Please note, tyres may be supplied only
partially inflated for shipping. Please inflate
tires to correct pressure before sitting on
your trike. The correct inflation pressures are
printed on the tire sidewalls.)
Main Frame, cruciform and rear section
(Vortex frames will arrive seperated) Front Boom
Air-Pro seat and Air-Pro seat pads (Hardshell
seat models) Seat cover and frame (Mesh seat models)
Rear Wheel (installed on 20 inch models,
supplied separately on 26 inch and 700c
models) Front Wheels (disc brake version shown –
wheels are shipped without rotors attached to
avoid transit damage)
Axle Bolts Rear Derailleur - attached by its cable and
fastened to the rear section