Page 30
Page 30
3.
Shut close the water shutoff valve on water
line.
4.
Remove the top panels to gain access to the
water reservoir.
5.
Remove the float reservoir cover and with a
piece of copper wire jump the two water level
sensors.
6.
Place a water pan under the freezer water
inlet port, disconnect the water hose from this
port and allow the water from the freezer to flow
into the pan previously positioned.
Then refit the water hose to the freezer water
inlet port.
7.
Prepare the cleaning solution by diluting in
a plastic container one or two liters of warm
water (45
°
-50
°
C) with a 0,1-0,2 liters of Ice
Machine Cleaner.
WARNING. The Ice Machine Cleaner
contains Phosphoric and Hydroxyacetic
acids. These compounds are corrosive
and may cause burns if swallowed, DO
NOT induce vomiting. Give large amounts
of water or milk. Call Physician
immediately. In case of external contact
flush with water. KEEP OUT OF THE
REACH OF CHILDREN
8.
Switch ON the Master switch to start the unit
then pour the cleaning solution into the float
reservoir.
9.
Wait for about three minutes for the unit to
start operating, then continue to slowly pour the
cleaning solution into the water reservoir taking
care to maintain the level just below the overflow.
NOTE. The ice made with the cleaning
solution is slushy and coloured also, it may
tend to loose fluidity creating some resistence
in being elevated and extruded; this situation
can be heard by the creacking noise made by
the ice.
Should this occure it is recommended to stop
for few minutes the ice machine in order to
allow the ice in the freezer to partially melt.
10. When all the cleaning solution has been
used up, open the water shutoff valve to allow
new fresh water to flow into the reservoir. Let the
unit to continue to run until the ice resumes the
normal colour and hardness.
11. Stop the icemaker and pour warm water on
the ice deposited into the storage bin to melt it up.
NOTE. DO NOT use ice produced with the
cleaning solution. Be sure none remains in
the bin.
12. Pour into the water reservoir 1 cc. (approx
20 drops) of Scotsman Sanitiser (Antialgae P/N
264000.00) then switch the unit ON.
13. Left the unit running for approx 10 minutes
then remove the copper wire used to jump the
two sensors for the water level and place back
correctly the cover on the float reservoir.
NOTE. DO NOT use ice produced with the
sanitising solution.
14. With a sponge moisted with a sanitising
solution, wipe clean all the bin interior surfaces.
REMEMBER. To prevent the accumulation
of undesirable bacteria it is necessary to
sanitise the interior of the storage bin with an
anti-algae disinfectant solution every week.
