ICE COBOTICS i-Synergy RS28L-CY, Руководство оператора

Страница: 8 / 45

8 ICE RS28L-CY
OPERATOR MANUAL
3. Position the machine on a dry dusty floor or apply a
powdered substance, such as chalk.
4. Do not sit in the seat and adjust the solution flow
to 0, trun on the 1-step starting button to lower the
Cylinderical head on the floor.
5. Press down the Propel pedal and let the Cylinderical
brushes work a while, and then turn off the 1-step
starting button to raise the Cylinderical head and
drive the machine away.
6. Observe the brush patterns. If the brush pattern
is the same width across the entire length of each
brush and both brushes are the same wideth (Shown
as blew), no adjustment is necessary. if it is uneven
or tapered, adjustment is required.
TO ADJUST A TAPPERED BRUSH PATTERN
1. Remove the brush door from the brush by loosening
the knob.
2. Hold the brush plug shaft with a wrench and loosen
the 6mm hex screw.
3. To lower the brush end, turn the shaft clockwise for
the front brush and counter--clockwise for the rear
brush. Retighten hex screw.
4. Recheck brush pattern.
NOTE: Replace brushes when worn to 5/8” (15mm).
MOUNTING THE SQUEEGEE ASSEMBLY
1. Turn off the 1-Step switch and raise the Squeegee
assembly off the floor.
2. Mount the squeegee assembly to the squeegee pivot
bracket. make sure the knobs are completely seated
into the slots before securing knobs.
3. Connect the Vacuum hose (Machine components,
#42) to the squeegee assembly. Loop the hose by
using the hose clip provided.
4. Check the squeegee blades for proper adjustment
by adjusting the Squeegee adjusting knob (Machine
components, #44).
FILLING THE SOLUTION TANK
The machine is equipped with a Hose fill port (Machine
components, #3)at the side of the machine, and a
bucket fill-port located under the recovery tank.
Fill solution tank with water (not to exceed 60°C/140°F).
Pour a recommended cleaning detergent into the
solution tank according to mixing instructions on the
container.
NOTE: Before accessing the bucket fill-port make
sure that the recovery tank is empty.
When filling the solution tank with a bucket, make
sure that the bucket is clean. Do not use the same
bucket for filling and draining the machine.
AUTO-FILL HOSE PORT(OPTION)
The machine have a optional Auto-fill hose port (Machine
components, #2), you can fill the Solution tank by using
filling hose equipped with Quick connectors.
1. Connect the Quick connector of the filling hose
to the Auto-fill port and connect the another end
to the water supply connector.
2. Turn the water supply on, the water flow will
automatically shut off when solution tank is full,
and then turn the water supply off.
3. Disconnect the Quick connector from the water
supply end first, and then disconnect the Filling
hose from machineand store in proper location.
WARNING: Do not put any flammable
materials into solution tank. this can cause an
explosion or a fire.
FILLING THE DETERGENT BOTTLE
The machine is equipped with a 4 liters Detergent
bottle under the Recovery tank. You can fill the
Detergent bottle by openning the Deterent bottle cabin
door (Machine components, #25), and removing the
detergent bottle cap.
The ratio of water and detergent is 0~5%, you can
adjust this ratio via pressing the Detergent adjusting
button (Machine components, #33).
NOTE: Only use recommended cleaning chemicals.
Contact your janitorial supply distributor for
recommendations on properchemicals.